Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,All of our C4948-10G have increasing "output drops" counters. Here's the example of port statistics (this is a SPAN port that drops packets continouslywhen port load is about 200Mbps/50k pps).GigabitEthernet1/1 is up, line protocol is down (mon...
Hello,We have the following network topology: - MAN ring (4 6500 switches connected in ring) in OSPF area 0 - remote location with 3750 stack connected via two fast ethernet uplinks to two of the cat 6500 in the MAN ring - this 3750 is in the differe...
Hello,We are having an issue with http based application loadbalanced by ACE - sometimes one of the page in the browser is partialy blank (some of the code referenced in main html document seems to be missing). We've discovered the following syslog m...
Hello,I have a problem with the following configuration of a sticky serverfarm with a backup serverfarm(this setup is ofcourse used only for failover purposes, not loadbalancing):probe tcp tcp-8888-probe port 8888 interval 5 faildetect 2 passdete...
Hello,I would like to configure tacacs+ aaa on cisco application control engine catalyst 6500 module. In the ACE configuration guide there is notice that one should configure additional parameters to be returned from the tacacs server (shell:<context...
Hello,In my case the problem was also related to vmware - too little RAM assigned to virtual machine - you should check your vmware settings.regards,WM
Hello,I have exactly the same problem. Install completed successfully, then the setup phase completed without any errors, but after reboot the application won't come up. (linux is comming up fine).It seems like there is no acs package installed at al...
