Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new 2811 switch. I powered it up and logged in as "cisco' pwd = "cisco'I got logged out before I set the username. Now I can't get logged back in.Do I have to power cycle it ? It is remote. I lost the connection. That's how I gotlogged out. ...
I am trying to allow SMTP through a PIX 525 running ver 7.2(2). When the banner comes back to the server it is 2's and astericks (*). I have done the "no inspection esmtp" commmand in the global policy, so that should turn off the inspection. However...
I have a Pix 525 with 7.2(2). I have the outside interface to a GSR using private IP's. I want external people to be able to establish an IPSEC Tunnel to this pix using a public IP. The GSR routes the public IP to the Pix. How can I assign the public...
I'm looking for a simple document that shows how to setup a IPSEC VPN tunnel between a PC running the VPN client and a PIX 525 runnning 7.2(2) code. The clients will establish a VPN connection to the PIX and we be allowed access to one Lan off the PI...
The device on the inside of the firewall is trying to connect to the mail server on the outside of the firewall. If I connect to the mail server from a device on the outside of the firewall the header returns fine. Only when the connection originates...
The GSR is not doing any NAT.The GSR is blocking nothing.The Pix has a public IP that is directly connected to the GSR. This is the Gig-e link between them. The GSR has a static route to another public IP that points to the Pix. What I want to do is ...
