New Cisco 2811 Switch

lkoons · ‎12-06-2010

I have a new 2811 switch. I powered it up and logged in as "cisco' pwd = "cisco'

I got logged out before I set the username. Now I can't get logged back in.

Do I have to power cycle it ? It is remote. I lost the connection. That's how I got

logged out. I get connected again and prompted for Username & Password but

cisco, cisco doesn't work.

Thanks for any help

Leo Laohoo · ‎12-06-2010

If you didn't save the config try rebooting the router. Otherwise you'll have to do password recover.

Ganesh Hariharan · ‎12-07-2010

I have a new 2811 switch. I powered it up and logged in as "cisco' pwd = "cisco'

I got logged out before I set the username. Now I can't get logged back in.

Do I have to power cycle it ? It is remote. I lost the connection. That's how I got

logged out. I get connected again and prompted for Username & Password but

cisco, cisco doesn't work.

Thanks for any help

Hi,

As leo suggested if not saved the configuration reeboot and check otherwise just break the password from the below link

Hope to Help !!

Ganesh.H

Remember to rate the helpful post