Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running out of IP's in a DMZ I have... I have a CSS in there.... Can I run a webserver on a different port of one of my servers.... and use the css to translate inbound port 80 and/or 443 traffic to the correct port based on URL?What would that ...
We do a basic load balancing configuration for https. 3 servers. 1 is currently suspended. Today one of the servers in the content rule crashed. After it came up it showed a current 3100 connections?!?!?!? and fluctuated by a few up and down.......
Can someone explain to me what the difference is when some of my content seems to load balance 'correctly'. Return traffic appears to be sent to the VIP... BUT some of the traffic I need to actually configure a group for... to get the return traffic...
I get the following error repeatedlyJun 30 15:54:03: %RTD-1-LINK_FLAP: FastEthernet0/22 link down/up 11 times per minThe link is admin'd downFastEthernet0/22 is administratively down, line protocol is downWhy am I getting the link flaps when the link...
I have a 2600 with a PRI card, when I try to do an isdn test call int s1/0:23 ######### the debug constantly comes back with "Cause i = 0x83E020 - Mandatory information element missing" Vendor states he doesn't see the SDN 'flag' coming through. I h...
AH... ok.That's good to know there is a limit... I see... then what this may imply is that the server went down... and the CSS was still sending traffic to it? possibly?!?! Before it showed as 'dying'... and then once it was 'dead' it stopped tryi...
Version: sg0750103 (07.50.1.03)Flash (Locked): 07.50.1.03Flash (Operational): 07.50.1.03Type: PRIMARYLicensed Cmd Set(s): Standard Feature SetBut 3000 connections? I don't think this server can handle 1000 c...
YES...!!!!!!!!!! that makes a lot of sense.... and was what I actually suspected but I couldn't find a link on cisco's website that would say what you just said.... THANK YOU!I thought I saw this very same problem though with port 8080 traffic.. tcp...
I am at a loss then because my CSS is responding differently for 2 different protocols... If I do NOT create a group for the DNS content the DNS server will reply DIRECTLY to the client with it's very own IP... not the VIP.... I did not have to do ...
