Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is correct, and it's no different than normal best practices without vpc.When you connect a server to a switch, that switchport should be configured as 'edge' or 'portfast'When you connect a switch to a switch, those switchports should be config...
Martin,In UCS Manager version 1.3 or below, if you connect a C-Series server to the 6100, you will need to run Switch Mode and configure the port as an "Uplink" port. Did you configure the port as an "Uplink" port?Cheers,Brad
The above answer is Incorrect. You CAN populate (2) DIMMs per Channel on the B200 M2 and the memory will clock at 1333Mhz (assuming you are using 1333 Mhz rated DIMMs - 8GB DIMMs or smaller). This results in up to 96GB clocked at 1333 Mhz.Cheers,Br...
