Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to know how to permanently enter in an IP-to-MAC address in the PIX's ARP table. I know that I can change the amount of time that the entry stays in the table from the default, but I need to know how to make it stay in there until manually rem...
I am looking for a document- if there is one, that lists all cisco technologies (routers, switches, firewall, vpn, etc) and all their software / image releases in the past 2 years.Would anyone now whereabouts I could get this info?Any comment is grea...
The NetRanger box I have is running Solaris 8 on Intel hardware. Is this always the case for NetRanger? ... or is there a choice for what OS you can run?Thanks in advance.
I have 2 pix 520's that were in storage and had previous configurations on them. When I power them on and try to connect to them via console (hyperterminal 6.3) , neither one of them responds. I don not see any boot up info either. These units are th...
Yes , I am sure... I think the default is like 14440 seconds (not positive thought). About every 4 hours the static arp entry disappears ..I had an issue similar to this a couple years ago and there was this advanced option that the TAC rep recommend...
Thanks for the reply but that is not a permanent entry. The entry will on remain in there until the ARP table times out...A member of TAC gave me a handle or option that would allow the entry to bypass the ARP table timeout. Does anyone know how to d...
