Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I tried to set Site to Site with FortiGate VPN.However, I wonder why it is not proceeded Phase-2 as follows.Can you check it please? crypto map outside_map 21 match address outside_cryptomap_21crypto map outside_map 21 set pfscrypto map out...
Hi,When I tried to reset VPN to the factory default configuration, it always failed as follows. 1) File > Reset device to the factory default configuration in ASDM menu,I cannot proceed next step after I input the management IP/Subnet and YES. After ...
Hi, I faced following NAT issue, Can anybody help me please. T_T DiagramUE(20.20.20.246~250/24) ---(remote access)--- (outside) VPN (AWS Interface: 20.20.20.1) --- Server(20.20.20.50)1) UE <- Server ping test (20.20.20.50 -> 20.20.20.247): success2...
Hello, I use CISCO ASA 5585 VPN and I faced some issue about NAT or Firewall. Please help me T_T Devices get an IP from VPN ip local pool (20.20.20.0/24) and they should ping with specific server as follows.from specific server(20.20.20.50) to device...
even if I capture with "ip" instead of ICMP, I can find icmp only as follows. And when I tried to connect using PC or other UE instead of my current UE, same issue occured (ping failure..) so.. if I cannot resolve this issue .. I will do factory defa...
I updated arp table in server side. it is the same with your expectation. The MAC adress of 20.202.0.247 is same as the ASA gateway 20.20.20.1.[root@Nable-mpGW ~]# arp -a? (10.251.212.5) at 00:03:2e:24:04:10 [ether] on eth9? (20.20.20.247) at 00:78:8...
Hi, I tried to compare failure case(20.20.20.247 -> 20.20.20.50) and success case(20.20.20.50 -> 20.20.20.247) using Packet Tracer function in ASDM. I found a difference in NAT so I tried to disable (aws, outside) NAT but that time, ping failure is a...
I hope we get closer to cause more, too !!I think my configuration result is the same with your simulation as follows. And I will try to check arp table in server side after 9hrs (because this server is in the company.) also.Result of the command: "s...
Thanks for your kind simulation.When I checked my NAT after I ping to server from UE, I found "untranslate_hits" in my NAT no.1 rule as you simulated. And ARP table is some different, I can only check 20.20.20.50 ip even UE gets 20.20.20.246 as follo...
