Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Boy, you got your hands full there. Check this best practice guide. Might have some useful information inside.https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-6/b_Cisco_Wireless_LAN_Controller_Configuration_Best_Practices.html#c...
Hey there,Go to Wireless- Global Configuration and set the TCP MSS to 1250 is one suggestion from my side. Might be having issues with fragmentation which can start increasing the latency. Although strange.Also get two devices on the wired network in...
The rommon mode also displays output in putty. Check your console connection. The changing lights as per the documentation means that the AP is still booting up.The proper way to factory reset the AP is to turn it off, press the mode button and hold ...
Yup, you can kill 12 and 18Mbps since you have a dense deployment. Leave 24 on mandatory.However, do that with caution for the places where the APs are not so close to each other. You can design an RF profile that would navigate certain APs data rate...
Hi, Would you mind showing the current Wireless config that you have.I am also trying to figure a way not to use the GUI, even though it is easy enough. Thanks
