Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,Is there an option to check the SFP type, installed on the MX Firewall.We use "show int status" to check the SFP type on each port and also show inventory to know all the SPF types.How can we find the SFP type in Meraki MX? Thanks Hame...
Hi Cisco Experts,Kindly need your advice on the below;Setup : Cisco ASA 5520Any Traffic from any source pointing to Destination IP (Ex: 192.168.10.10:53) to be NATed (Destination Translated) to 172.16.10.10:53. The ASA will have route to 172.16.10.0/...
Hi...We have a ACS Appliance integrated with MS AD and users are authenticated successfully. Our Requirement is that, we have 3 Departments with 20 Edge Switches each. I have created 3 Network Device Groups (NDG) for each department in ACS with 20 Sw...
Dear Security Experts,I am facing a issue in FWSM. I couldnt even get a clue why the nameif command is not working in Fwsm. All the required commands are done in CoreSwitch (Vlan group etc) and i can see the vlan also in fwsm.please gimme some hint t...
Dears,As we know in Routers, we create a local Username/password and configure the vty line with "privilege level 15" command and the user will go directly to priv mode.how can we do this in ASA/FWSM??? I have done AAA and also Local U&P, the users g...
Dear Cisco Stars,I do have the same issue with all my 250 New IP Phones connected on stacked 3750. I am currently running 12.2 53 SE2.When i remove IPSG, the IP Phone works fine.Please keep us posted with any possible developments..Thanks a lotJafy
Hi Nagy,Thanks for your response.. Let me be more specific..My Host IP: 10.10.10.10 (Source)My DNS IP: 192.168.10.10 (Destination)IP to be Translated: 172.16.10.10 (Xlated Destination)The actual IP address of the DNS is 172.16.10.10 and i dont my LAN...
Dear Mr.Adam,Great to see you replying my post...Yes.. I have done this command and tried and it didnt work. then, i tried the other command too (enable console LOCAL) (Just to make sure)aaa authentication telnet console LOCALaaa authentication enabl...
