Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a ACNS version 7326 runing .i need to figure out the indept utlisation of the box along with the rules configured in it . Also how do i check if the box are configured int he failover mode .Can body help me with the ACNS torublshooting .Than...
Dear AllI have configure 2 Cisco ASA 5550 firewall in Active Standby . Both the firewall are connected back to back . Both the firewalls are running software version 7.2(3). Below are the detais .The poblem ia am bale to telnet the active firewall b...
Dear AllI have 4255 cisco sensor i want to have authentication done via Tacacs server .All my router and swithces are configured for tacacs authentication .The same need s to be applied on the sensors .Can this be done.RegardsUmesh Gurav
Dear TeamI wantot know the exact step /configuration as to how do we update the signature on the ips . I need to update S478 signautre .Kinldy send me the step for the same .RegardsUmesh
DC-MUM-FW5550# sh interface gigabitEthernet 1/3Interface GigabitEthernet1/3 "FAIL-STATE-LINK", is up, line protocol is up Hardware is VCS7380 rev01, BW 1000 Mbps Auto-Duplex(Full-duplex), Auto-Speed(1000 Mbps) Media-type configured as ...
time-range internet periodic weekdays 9:00 to 18:00ip access-list extended strict deny tcp any host 172.16.0.1 time-range internetinterface FastEthernet0/0ip access-group strict inAbove is the router configurations but the access list says inactive...
Dear AllKindly download the trail version software from kiwi site and enable the logging on the router.Add the router interface in the kiwi syslog log Please revert back.
