Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experiencing extremely high CPU utilization on my Cisco 2821. I am using this router to handle several (120-125) GRE tunnels. I am also experiencing large amounts of input errors on both of my gigabit ethernet interfaces. All of my GRE tunnels a...
I am having problems with my ACS servivces failing to start properly after the OS is rebooted. The server is a VM on ESXi. The services also have problems starting after one fails on the reboot.
I actually have a 2851 setup as my standby router but I don't think I would gain anything by using it over the 2821. I did find that some of my traffic is passing through the router twice and one a lot of the trips it is going in and out the same int...
#sh proc cpu sortedCPU utilization for five seconds: 80%/79%; one minute: 79%; five minutes: 79%PIDRuntime(ms)InvokeduSecs5Sec1Min5MinTTYProcess6626946744832459893230.40%0.39%0.35%0IP Input34269410867444703990.40%0.11%0.10%0Net Background129180154011...
