Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any way to verify that I am getting full T1 from my provider? We have 1600 routers on this private T1. I'm using MRTG and I'm never seeing usage go more than 50% even though there are (600mb) file transfers at night.thanksRG
I currently have two internal Win2K3 DNS servers on my internal network that had been working fine. I tried to upgrade my PIX os from 5.1.2 to 6.3.x but that stopped all traffic. I downgraded to 5.2.9 which allowed at least email to flow in again. ...
I'm looking to setup a RAS server on my Internet 2600 router that is outside of my firewall for 2 or three dial-up users. One they've gone through the dial-up authentication then they would go through a VPN 3005.I'm having a hard time finding inform...
I'm not sure what I'm doing wrong but I can't get my vlan routing to work with my subinterfaces on a 3550 switch. the port on the switch is configured like this:interface FastEthernet0/21 switchport trunk encapsulation dot1q switchport mode trunk no...
I'm learning the CatOS and so I'm having trouble with my config file. I did some changes to the running config and now I want to save it to the startup config. If this was an IOS, I would do copy run start and that would be it. How do I do it now?...
We are in the process of implementing about 60 5220 phones here on their 3300 pbx. We encountered a lot of problems with the PBX software which was initially blamed on the network/QoS setup. The way I proved them wrong was by plugging 2 phones dire...
Thannks, I feel a little silly that it was so simple. Are there any docs you can point me to that will help me understand the way the filesystem works? I'm having a bit of trouble getting comfortable with the CatOS vs IOS.
update:I opened a case with Cisco and there telling me there was some sort of design issue/limitation on these cards. The tech said I need to separate these two VWICs into two different NMs on the router. (which defeates the purposed of getting the...
I've read this and I'm still having issues. I tried something for the heck of it:I made the remote site (2600 WIC-1DSU-T1) clock source line and then set the home site (3600 VWIC-2MFT-T1) to clock source internal. It would no come up with this setu...
Yes indeed I am having problems with T1s. I have put in several tickets with AT&T with no resolution. this is a point to point T1 with the other end point set to "clock internal" and this end to line. The far end also has no errors and when AT&T l...
