hi, are there any Cisco products equivalent to Nortel's PBB/PBT technology?to me, it seems like it's just L2VPN, but not through MPLS cloud.what's the difference between the two, then?
consider:r1 -- r2 -- r4 -- r5 \ / r3where r1,r5 are PEs and r2,r3,r4 are Ps. r3 is a backup router in case r2-r4 path is down (the picture doesn't show up properly).assume r1's ip route table picks r2-r4 path to go to r5. my dillema...
hi, what happens if there are multiple routes with the same route-target are received for a particular FEC? what BGP route selection process (in what order) will a cisco router select (i.e. the best route)?thanks.
does any of you know what 'recursive rewrite' mean?simple setup L3vpn, PE1-P-PE2.in PE1 i use c7500 which has GE and FE interfaces. PE1 can't reach PE2's vrf_1 if FE is used. GE is ok. i found the following, which points to the difference between GE ...
thanks Martin, but for some reason, the tag works now after a reload. i was in the right direction, but wasn't sure if it has something to do with hardware limitation.the answer is NOT. here's what the fec looks like now:pe1_cisco#sho mpl for 50.0.0....
Mahesh,are you sure you don't need:ping vrf ABCD 'CE' source 'one of your ABCD i/f'??it should work if you specify source since this is vrf-specific ping.
