Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco IE 3010 switch, for which I need to reset the enable password via console. I tried the steps listed in the URL for recover password for forgotten or lost password at cisco website. When I perform these steps, either switch is completel...
Can we create a VXLAN underlay using VLAN interfaces instead of assigning IP-Address directly on the physical interfaces. sp-i# sh ip int brief vrf allIP Interface Status for VRF "VXLAN"(7)Interface IP Address Interface StatusVlan1...
Need assistance for confiuring SG350 switches for TACACS. I have used the below URL for configuring ACS on my SG350 switch.Port TCP/49 is allowed from my switch to the TACACS server.But still the status not connected on my switch when i run the comm...
Actually, I don't want to a full factory reset. As I forgot the enable password for the switch. I'm looking for ways to somehow reset/reconfigure the enable password.I tried these steps, but it is somehow not working from step3Recovering from a Lost ...
Hello Hector, Thanks for your reply. The reasons for having a different setup is that, I have multiple Vlan-interfaces created on the links which are connected to Spine-Leaf in different VRF's. I don't want to change this.Will it work if I want to cr...
