Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
@CthulhuSamurai wrote:I am trying to create a ROAS in Packet Tracer and have come up to a wall. In the attached file I can not ping the hosts of one VLAN to the other. I can ping hosts on the same VLAN and the gateway. I am really new at this and ...
Hi, can you please post the switch configuration?Also please elaborate on the source of the pings, possibly post a diagram of your topology too. Cheers;
Hi, you're pretty much spot on.The advantage of using sticky (and subsequently have the dynamically learned MAC addresses in the running config) is the ability the save them to the startup config and have them persist after a reboot, thus making the ...
Hi What VTP mode is the switch currently operating at?VLANs in the extended range (from 1006 to 4094) can be only be created while the switch is in VTP transparent mode.
Hi, unfortunately you've misconfigured the interfaces.See attached image.- The interfaces of the segment between the routers (highlighted in yellow) are not on the same subnet.- Once you'll switch the addresses between Fa0/1 and Eth1/0, you'll have a...
