Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Whats the difference between VoIP and VoFR?Which is better to implement on the network scenario below?Setup:1750 on 2 location. Connected via 64kbps frame-relay with burst up to 128 kbps. On Site A is a FXS and on Site B is a FXO.any sample configura...
Is there a way of limiting how many NAT traslation I could statically map to? If yes how do I disable it.I'm trying to troubleshoot a client PIX. It have been configured by somebody before and he gave-up troubleshooting what he configured.My problem ...
I have configured both Callmanager 3.0(9) and Cisco 3660 with IOS 12.2.2(XA) for MGCP gateway. The gateway can see the callmanager and also the callmanager can see the router. I have also configured the route pattern of 9.@. When I dial 9, I don't ge...
I've setup Callmanager 3.0(7). It has basic configuration. I can now communicate between IP Phones. How do I configure my 1750 as the PSTN gateway of my Callmanager?I'm new to callmanager so somethings might not have been configured or familar with.L...
Is it possible to bridge ip traffic without routing ip?Here are the configs on my 2 routers. Can someone tell me whats wrong?Cisco_805!no ip routing!int ethernet0ip address 212.0.1.254 255.255.255.0bridge-group 1!int serial 0ip address 212.0.1.254 25...
Is it configured as MGCP for the CCM?Can you help me with my problem?I tried to upgrade to 12.2.6 enterprise plus but I can't seem to find the ccm-manager command?Or should I get a different IOS?Thanks.
It now calls the other end of the line. But still there is no dial tone after I dial 9. When the other line answers the phone, the call is disconnected.
