Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone,
I'm new to Cisco and trying to figure out how I can get my routers to give internet to my switches from my ASA 5505.
My current topology looks like this: Modem - ASA 5505 - Cisco 1841 - Cisco 2950 - end device
I can get internet acce...
Hey everyone, I'd really appreciate some help on this. I'm brand new to networking and I recently setup a new Cisco 2960 switch that I'm trying to access remotely using telnet. I can access the switch over my LAN, on the same network, however, if I g...
Hey Tim,
ok so everything worked up until that last part where I tired to ping 8.8.8.8 and then it failed, which like you mentioned, it could be the firewall.
So from here, what would you suggest for the firewall?
Thank you very much again for your...
Hi Tim, thanks for the help here.
When I ping the IP of 11.0.0.1, I get destination host unreachable. It does that with every IP I attempt to ping though because I am not connected to the internet when attempting to troubleshoot (until I go on wifi t...
Hi Aditya,
I issued the command tracert 8.8.8.8 in my command prompt and then set the default gateway to the next hop IP out of my LAN but it did not work. Please let me know if I did this right.
Just so you see where I got the info from:
How I f...
Hi Aditya,
Ok, I issued the command "show ip default-gateway" and got a result of 0.0.0.
Switch#show ip default-gateway0.0.0.0
For the default gateway, should this be setup as the default gateway of my router? For example my router default gateway ...
