Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have installed AutoAttendant in Call Manager 3.3 release. I have two regions one is default and the other is remote. I am using G 711 Codec for Default as well as remote region. But for the inter-region calls i am using G 729. When i call the ...
Hi, I have a Call Manager and IP Phones behind a Firewall. At the other side of the firewall i have a router with 2 FXS ports. I have connected two analog phones to these FXS ports. Now in the Call Manager i have added the router as a H 323 Gateway ...
Hi, I have two locations A and B respectively. Call Manager is located at locationA. IP Phones are installed at both the locations. The phone numbers at location A are (651)1001, (651)1002 ..so on. The phone numbers at location B are (450)1001, (45...
Hi, I have a 64k leased line between two sites. Can i have a configurationlike thisinterface serial0 no ip address encapsulation hdlcinterface serial0.1 ip address 10.10.10.1 255.255.255.0interface serial 0.2 ip address 10.10.20.1 255.255.255...
Hi, I have a 3660 Router with 4 NM 8A/S Cards with IOS version 12.2.12Various Branches are connected to these cards thru serial line, HDLC. After few days some ports of the router show that line protocol has gone down. But when i reload the ro...
I have faced the same problem and done this configuration. And now my configuration is getting saved properly. But do i need to configure any startup parameters after this configuration? my concern is that when the switch startup, how it will recogn...
Hi, Thanks for the reply.If i correctly understand i need to open the following ports at the FirewallUDP 16384 - 32667 ( for rtp traffic b/w Phones )UDP 1719TCP 1720TCP 11000-65535 ( for H 323 Communications )My doubt is can the communication betwe...
Thanks for the reply. When i am connecting both the server aswell as the client onto the switch the client is able to communicate with the server. When i am connecting the client to a Hub and then hub to the switch then the client is not able...
