Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I would like to test the bandwidth between different locations. Under the item Troubleshooting there is the possibility to do a speed test.Is this speed test meaningful?
At two locations I know that I have a synchronous 1000Mbps line. However,...
Hi, i have 2 AP´s 2802e with the Mobility Express Software on it.I used the WLAN Provision to do the initial config.After this i install a dhcp so the two AP can find each other.Mobility Express: static IPAP: DHCPNow i wanna have static IP for the tw...
Hi,
is run in this error since i updatet to 3.4. Is there already a workaround for this issue?
It is also strange that I can make backups to the repository, but these are then not displayed in the gui.
prod-ise-pan-01/admin#show repository sftp6 [356...
Hi,
I had opened a TacCase for this purpose.It does not seem to be possible to do this with Viptela's own resources.Then I will have to look for other tools.
Thanks again
Hi,
thanks for your quick reply.
Do you have a tutorial on how to do such a test?
I have found the following commands:tools iperf vpn 0 options "-c IP address -u -b bandwidth".
But this command works only on the Viptela devices.
The output is:
SDW# t...
After I change the Config from the AP on the WEB GUI the AP directly restart, he change the name and all other settings for antenna that i made, but only the static ip change dont have a effect. after the ap reboots it has a new name but also change ...
