Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two routers connected with multiple switchs beetween.I'm encountering a problem for forming adjencies in OSPF.I don't understand something, all my interfaces are with 1500 mtu value. But when i put a link beetween two switchs in trunk mo...
Hi, Certainly a stupid question. But if i put a license with 250 mega bandwith on the router.If i did some subinterfaces with rsvp reservation , this reservation is directly include on the global bandwith ?Or its just by interface ? And after limita...
Hello, Im trying to downgrade an isr 1100 séries router in a classic iOS xe. I receive the router in viptelia iOS , first i Switch to an iOS sd wan with success. Now i m trying to change 17.6.3a sd wan to 17.6.3 iOS xe. I follow the procédure but i C...
Hello,I have some questions about this routers series.I understand this series is for SD WAN router, i am right ?The router factory configuration is with and vedge IOS.By default all the interfaces are linked to the VPN0, is it possible to use this ...
Hi everyone, I have few questions about spanning tree protocol. My first question is, if it's recommanded to activate spanning tree on all the port of a switch. If i'm not wrong, some vendors like HP has loopback detection witch can be apply direct...
I tried a request platform software sdwan software install. Without success, 'Invalid installation package.Platform C1100 does not match with ISR1100be'.
Here the problems : Router#controller-mode disable% Controller to Autonomous mode change blocked: This platform does not support switching to autonomous mode. rommon 3 > boot bootflash:c1100-universalk9.17.06.03a.SPA.binLocated c1100-universalk9....
