Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Note the allowed frequencies.. On 3 other AP's this has values.. Same with allowed power levels.interface Dot11Radio1
Radio Antigua 5, Base Address 00a6.ca6f.96c0, BBlock version 0.00, Software version 4.18.1
Serial number: FOC20304KTF
Unused dynamic...
Confused.. I know commands changed in 15 from dot1x ... to authentication ... etc. I have this working on oth 2960S's, but on this 3560G, I have no "authentication" or "dot1x" commands on a per port basis..sh run <snippit>aaa new-model!!aaa authenti...
So first post, I usually figure most of this stuff out. I have this all working with latest firmware etc, but I have more of a MS IAS issue than anything. The Peap cert used is one generated for my IAS controller, but I have two things... I'd like it...
Well thats annoying...Step 9 swtichport mode access(Optional) Set the port to access mode only if you configured the RADIUS server in Step 6 and Step 7.That isn't optional (otherwise there are no interface authentication commands).
Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 52 WS-C3560G-48PS 15.0(1)SE2 C3560-IPBASEK9-MI'm still confused.. this works on a 2960S (same IOS v...
Well, thanks for that. It confirms that the features should be supported by the IOS/hardware, however my problem of the commands not being recognized still exists.Any thoughts?
sure, I understand and have done that, but only am prompted to use domain controller cert template. Any thoughts about my other (poorly phrased now that i look at it) question about having multiple IAS servers using the same certificate? Right now i...
