About cvoisin

cvoisin · 03-29-2008

I have a brand new 4507 with a supervisory engine 6-E and I have two odd issues. The first is the flash card. I am trying to store the image on the included compact flash card and I am having problems even formatting the card(s). Below is the outp...

cvoisin · 09-28-2012

I have the same issue. I've installed the dev packs and it still isn't working. I think that's a red herring. The described section doesn't say anything about directories not working, it says the phone won't register. Registration is working just...

cvoisin · 09-18-2010

The solution to fix your issue is simple as I was just experiencing the same problem. The problem you are having is with the SCSI controller that VMware defaults to use when creating new VMs. You need to change your SCSI controller over to an LSI L...

cvoisin · 04-01-2009

I'm not sure if you guys are misinformed, but stateful IPsec failover is NOT supported by the ASA. This was confirmed by my local SE. Your SAs will need to be purged on the remote side.Our ASA right now is flaking out on the primary and is failing ...

cvoisin · 04-01-2009

In my experience, with ASAs what will happen is the SAs will indeed move from the primary to the standby ASA. The standby ASA becomes the active ASA. The remote sites still think the original ASA is still up and unfortunately still hold onto their ...

cvoisin · 03-29-2008

When you plug a console cable into the switch, check to see what the switch is prompting you with on load. If the boot variable is not good, or if there are no images stored on either the bootflash or the slot0: directories. What you can issue at t...

Member Since	‎06-07-2004 05:08 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

New 4507R-E with Sup6-E

Re: 8945 Directory issue with firmware 9-3-1-19

Re: cucm 8 on vmware

Re: L2L VPNs on ASAs and failover question

Re: L2L VPNs on ASAs and failover question

Re: Catalyst 6509E new install goes to rommon