Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to acces a new aironet 1142n. I have tried to access the CLI and get into config, it comes up that config is not supported.I try and get it an ip address from my dhcp server, can not access it that wayI have tried to telnet to it, i...
Hello, the company i am working for is getting ready to remodel the main conference room. I need to make sure i am going to have the items i need for voice and video installed into the budget. What are the main things I will need to get in order to c...
I am looking for an USB to RJ45 adapter instead of using the Cisco RS232 to RJ45 adpter. the laptop I am using no longer has the RS232 adapter. Any ideas where to get one and why Cisco does not start to supply these with new units now.
Since i am not sure how you have the system setup, i am going to take a guess at this. If the DNS is being fowarded to the unit and going though the firewall, does the firewall allow the DNS request from the unit. ALso is the unit able to foward the ...
Hello, I am having the same problem. I came accross the following link that will explainwhy you can not connect to the AP point with the 2.4 Ghz system. You will need to upgrade to the5 Ghz system. I have tried a lot of different settings on the AP p...
you need to bypass the startup config. Press and hold the botton during startup till you get that screen, After that type in :flash_init" and "load_helper". once you do that rename the flash:config.text flash:config.old. after that is done then boot....
