Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What I am trying to configure is Mobility Groups.My understanding is that this will allow AP to successfully register and fail over over seamlessly if any of the WLC had to fail ?It could be I am confusing two things into one & I am totally confuse...
I am trying to get setup with my WLC 5508 and I have run into the next set of challenge... Software version : 7.6.130.0FRI: 7.6.101.1 My first AP out of the box started up and received an ip add and was listed under Wireless > ALL APS status "Downloa...
This is my first attempt to set-up a WLC so please bear with me...My current set-up is as follows:-WLC 5508 Version : - 6.0.199.4Field Recovery Image Version:- 6.0.182.0LAG : - Enabled ( during the initial set-up Wizard)Port Configuration:- Service P...
Current Situation:----------------------I have recently started a new role and this network/infrastructure is in complete chaos which is an understatement. So a lot of changes need to be made to get things right.Network/Infrastructure background:----...
So as I understand it I will have the following setup in the end. 2 * WLC on LAN running 5508 ( 1 with HA SKU ) 2 * WLC in DMZ running 5508 with (5508-12-K9 license ) running as Anchor in the DMZ. So I will need two Mobility groups:-1. for my 2 * WLC...
So basically the way I understand it is I don't need to worry about the HA setup under AP as I have AP SSO configured as the configuration is in sync. As for Mobility group that is used for client roaming between AP correct ?So the users on this netw...
Thank you for your response I had already left for the day hence the delayed response.Here are my findings. 1. You are correct the country was not set correctly and I kept ignoring the irritating message box but it was advising me to disable the radi...
Would this be the correct value for WLC within DHCP for the above mentioned AP?I need to deploy 1552i + 3602E in this project...0xf1040A1F6315 ( with no "spaces" inserted into the ASCI section of Windows DHCP option 43)10.31.99.21The AP keeps flashi...
I read some text on-line which was conflicting but I tried it any ways and no joy. Tried the AP switch port as Trunk - No joy ( it would not even get an ip add from DHCP )Tried the AP switch port as Trunk + native vlan set to AP - No joy ( it would n...
