Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm really REALLY hoping this is something stupid. I have an 861W on a 10.1.1.0/24 subnet - only the f4 interface is configured and connected. It has the correct subnet and the correct gateway configured for the subnet. Anything on that subnet can...
What command on the Pix (v 6.3.1) clears the access-list hit counts? In the command reference the closest clear command I can find is the clear traffic, which clears traffic counters on each interface.Thanks in advance
I have a 515, running 5.3, with 5 interfaces and have a device connected to the subnet to which one of the lower-rated interfaces (it is rated 50, one beneath it is 30, and outside is 0, and two above it at 50 and 100) is attached. I can ping the lo...
I have a Windows 2000 member server I am trying to install ACS on. The install detects 'a process that is using the RADIUS ports'. I have port-scanned this server and the only port open that is close to the 4 common RADIUS ports (1645, 1646, 1812, ...
MY hope/wish was granted - it was something stupid. Guess I just don't configure routers often enough. A default route to the default gateway for that subnet did the trick. I guess a default gateway by itself is insufficient.Thanks again Alain and...
Thanks Alain,Here's the output:Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E...
