Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are we missing? It seems like it would be something simple, but we are overlooking something. We do not have a router in the mix. We have a Cisco Firepower 1120 Threat Defense Firewall running in router mode and a Brocade Ruckus ICX 7150 Layer ...
We are working with a Firepower FPR 1100 series firewall in the main office and a remote location with a layer 2 switch. On port 2 of the firewall, we have a server with IP address 192.168.1.3. At port 9 on the firewall we are connected to a switch...
I have a Cisco ME 3400 Layer 3 switch connecting via fiber link to a B&B SEG510-2SFP-T layer 2 switch with multiple devices in separate subnets and vlans connecting to the layer 2 switch. The diagram below shows the basic layout. I have the follo...
Issue Resolved! We added the following route on the switch: ip route 0.0.0.0/0 192.168.2.99 On the firewall we enabled port 1/6 with an IP address of 192.168.4.99/24. We moved the laptop from port 1/8 to port 1/6 and set the laptop IP to 192.168.4...
A quick note for ip routes in the firewall and switch. From the firewall show route:Gateway of last resort is 192.168.2.1 to network 0.0.0.0 S* 0.0.0.0 0.0.0.0 [1/0] via 192.168.2.1, bridgegroup1C 192.168.2.0 255.255.255.0 is directly c...
I really need to delete this entire question and start over. Thank you for your input as it was spot on with the gateway question. We've done a lot of configuration since this last post and will need to update it completely (will start a new thread...
Thank you for the suggestion. This layer 2 switch is a little difficult understanding. Port 4 is the camera and port 9 is the link to the layer 3 switch (the layer 3 switchport is indeed trunked.) !interface gi4 switchport mode hybrid switchport hy...
