AnyConnect Eventlog Errors
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-06-2011 08:56 AM - edited 02-21-2020 05:04 PM
Does everyone else get an exorbitant number of entries in the Application and AnyConnect event logs when using anyconnect? In Application, there are four events with ID 1001 that come in every minute when anyconnect is connected. Three say libcsd is the source and one is unknown. In the AnyConnect logs, there is a 3003 event that says 'Hostscan warn: failed to initialize mozilla certificates' and that comes in every minute as well once connected
I have tested with difference versions of anyconnect, CSD and ASA code and they don't seem to go away. I have asked Cisco about this and they say it's a design bug and will be addressed in future releases. As you can imagine, it can make troubleshooting difficult when weeding through all these entries.
- Labels:
-
AnyConnect

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-06-2011 02:39 PM
Hi,
This is normal-in-most-cases behavior with anyconnect/csd in current implemetation (I'm talking AC 2.5.2xxx & CSD 3.5.xxxx).
Most of the messages pop up when you connect intially and on top pop up during periodic checks run by CSD.
If you think it makes your life miserable put yourself in TAC's shoes :-)
Marcin
