AnyConnect not using IPsec

[chris.jinks]

Hi,

I'm using AnyConnect 4.9 on an FTD 2120 via FMC. I have enabled IPsec ikev2 and the associated policies however when I connect to the VPN i can see the method was SSL not IPsec, does anyone have any ideas as to why its not using IPsec?

-

Cheers,

Chris

[Rob Ingram · Accepted solution]

Hi,

You need to configure an Anyconnect XML profile and deploy to the client computers which specifies to use IPSec, by default it will connect using SSL otherwise.

HTH

[chris.jinks]

Hi,

I have a profile/ xml file however, i didnt see any section to specify IPsec in the Cisco profile editor

[chris.jinks]

Ahh found it, your right. Thank you very much