Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm looking at using a 5545-x with firepower to permit http/ https access to the internet for domain users or at least for a specific AD group, I found this link https://community.cisco.com/t5/security-documents/asa-idfw-identity-firewall-step-by...
Hi,We have some FTD devices in Azure that are behind a public IP, so the FTD does not have a public IP on the outside interface however it is assigned one and this works fine. For example, I can connect to the FTD over AnyConnect without issue. My qu...
Hi,I'm trying to config the load-balancing mechanism for a port-channel on a Cat 1000 switch however it doesn't recognise the command port-channel load-balance src-dst-ip WAN-site-sw-A(config)#port-channel ?auto LACP auto for the system Any idea?
Hi, On a new Cisco C1000 switch, what is the purpose of the above policy-map as part of the auto qos, from what i can see even when its assigned to a client-facing interface there are no actions other than identifying the traffic, am i missing someth...
Hi, I'm looking at a QoS policy for our C1000 switches, In short, i need our Cisco phones trusted and also our workstations as we have configured a group policy that sets the DSCP markings for teams.exe to EF (46) My question is which Auto QoS conf...
Thank you, how do you tell the router what the peer identifier is? so it knows the true IP address of the other end along with the peer address. From pfsense, peer identifier = Identifies the peer on the far side of the tunnel.And since the FTD doe...
SW-A#show etherchannel load-balanceEtherChannel Load-Balancing Addresses Used Per-Protocol:Non-IP: Source XOR Destination MAC addressIPv4: Combination of both SRC-DST-MAC and SRC-DST-IPIPv6: Combination of both SRC-DST-MAC and SRC-DST-IP Presumably,...
