AnyConnect PSK and username/password
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2023 11:28 AM
New to Meraki and trying to configure our client VPN with AnyConnect, I have downloaded the client software and profile editor. I am trying to configure with pre-shared passkey and each user using credentials when signing in. Looking at older posts I am not sure if this is still possible or how to excite a word around so ay guidance appreciated.
- Labels:
-
AnyConnect
-
VPN
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2023 11:50 AM
@gregoryy you cannot use PSK with an anyconnect VPN. Use username/password, MFA/2FA and/or certificates.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2023 11:56 AM
Is the MFA/2FA still using a username/password?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2023 11:59 AM
@gregoryy MFA/2FA is username + password and one time pin/passcode. Solutions such as Cisco Duo.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-14-2023 08:53 AM
Do you know if this is possible to configure without ASA or ADSM software? We only have the meraki basic dashboard.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2023 11:53 AM - edited 11-13-2023 12:16 PM
