Hi.
I have a cisco ASA 5506-k9 and trying to configure IPsec VTI on it and tried inputting command of interface tunnel 10 in global configuration mode, but an error accrues saying "ERROR: % Invalid input detected at '^' marker". so I used ? after interface then there is no any commands or options of tunnel after that. I also followed manual that provided by cisco but did not work out.
I think the 5506 supports tunnel interface but i just cannot do that and cannot figure what issues are in this case.
crypto ipsec profile command is same as tunnel interface. there is no option of it.
I have been struggling with this for over 2 weeks and i really need your help.
Best,
Kazuki
