Hello,
I'm having some issues using the autocommand feature and I wanted to see if anyone was experiencing anything similar and what the solution might be. Ultimately I am setting up an audit account that will need to run the show version and show run commands and that is it. I thought doing this via autocommand would work, especially for the show run command as we would prefer if this needed to be a priv 15 user that it not remain logged in. When I try and setup the autocommand for this specific user it does not seem to work at all. When I set it up for the vty lines it works as expected, however it has the same behavior for anyone logged into those lines. So, basically my questions are. First, how can you configure the autocommand feature for the user to work properly and second, is there a way to ssh into a specific vty port?
Thanks for any feedback!
