I cannot even see my customer connecting to the line,
router info
3845
IOS c3825-ipbasek9-mz.124-8c.bin
line 1/6
session-timeout 20
no exec-banner
exec-timeout 0 0
modem InOut
autocommand telnet 192.168.80.2 1389
terminal-type vt100
no exec
transport preferred telnet
transport input telnet
escape-character NONE
stopbits 1
flowcontrol software
3845#sh line 1/6
Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1/6 72 TTY 9600/9600 - inout - - - 0 39491 0/4 -
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 1 stopbits, 8 databits
Status: Ready, No Exit Banner, CTS Raised
Capabilities: EXEC Suppressed, Software Flowcontrol In,
Software Flowcontrol Out, Modem Callout, Modem RI is CD, No login banner
Modem state: Ready
Modem hardware state: CTS DSR DTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
none none ^S ^Q none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
never 00:20:00 none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: 1w1d
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are telnet.
Allowed output transports are pad telnet rlogin lapb-ta mop v120 ssh.
Preferred transport is telnet.
Automatically execute command "telnet 192.168.80.2 1389"
No output characters are padded
No special data dispatching characters
any ideas?