cannot login to switch from Access Server

[Ufuk Eskici]

Hi,

I cannot login to Switch (C3560) from Access Server (2511)

I configured the username and password on Access Server. I always get this username & password screen, but then nothing happens.

---------------------------

TERMINAL_SERVER#telnet SW1
Trying SW1 (10.0.0.1, 2001)... Open

User Access Verification

Username: ufuk
Password:
Password OK

-------------------------------

Switch command prompt is not comming. I use Ctrl-Shift-6 + x to cancel the connection.

What is the problem? Access server configuration is attached.

BR

[Jennifer Halim]

Can you also share the configuration of the 3560 switch, and also make sure that it is connected to the correct switch from the access server. Thanks.

Are you able to connect to the switch directly and only connection from the access server is failing?

[Ufuk Eskici]

I've attached it.

I have two C3560 switches and I cannot connect both of them from the same 2511.

I can connect to switches from their console port successfully.

[Jennifer Halim]

The attachment didn't seem to get attached --> "C3560.log.zip (1.6 K) QUEUED".

Can you please reattach it again? Thanks.

[Ufuk Eskici]

Please check the attached config.

[Ufuk Eskici]

It always queued.

[Ufuk Eskici]

the files are OK!

[Jennifer Halim]

Can you try to change the following:

From:

line con 0
transport preferred none

To:

line con 0
transport preferred all

[m.kafka]

maybe you are not using a roll-over cable between access-server and switch console, make sure, that rx and tx on the cable between access server and console are crossed out,

see also:

https://supportforums.cisco.com/message/3286989#3286989

(looks to me the same)

rgds,

MiKa