01-01-2011 04:29 PM
Hi,
I cannot login to Switch (C3560) from Access Server (2511)
I configured the username and password on Access Server. I always get this username & password screen, but then nothing happens.
---------------------------
TERMINAL_SERVER#telnet SW1
Trying SW1 (10.0.0.1, 2001)... Open
User Access Verification
Username: ufuk
Password:
Password OK
-------------------------------
Switch command prompt is not comming. I use Ctrl-Shift-6 + x to cancel the connection.
What is the problem? Access server configuration is attached.
BR
01-01-2011 06:51 PM
Can you also share the configuration of the 3560 switch, and also make sure that it is connected to the correct switch from the access server. Thanks.
Are you able to connect to the switch directly and only connection from the access server is failing?
01-02-2011 02:38 AM
01-02-2011 03:29 AM
The attachment didn't seem to get attached --> "C3560.log.zip (1.6 K) QUEUED".
Can you please reattach it again? Thanks.
01-02-2011 06:43 AM
01-02-2011 06:54 AM
01-03-2011 09:57 AM
the files are OK!
01-04-2011 02:43 PM
Can you try to change the following:
From:
line con 0
transport preferred none
To:
line con 0
transport preferred all
02-06-2011 10:40 PM
maybe you are not using a roll-over cable between access-server and switch console, make sure, that rx and tx on the cable between access server and console are crossed out,
see also:
https://supportforums.cisco.com/message/3286989#3286989
(looks to me the same)
rgds,
MiKa
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide