CISCO 700 and privileged EXEC mode

[ake_astrom]

Hi!

I have a CISCO 765 and trying to connect to another 765 and the result of the dailing is

"L08 1 0498291725 Call Connected

Connection 11 Add Link 1 Channel 1

Connection 11 Remove Link 1 Channel 1

L13 1 Disconnecting Call

L27 1 Disconnected"

This dosent say so much so I need to enter the debug mode. But how do I do that on the 765?

[thomas.chen]

Are you getting any other error messages through the console. Try enabling "debug isdn q931" on the router and check for the reason the call is getting disconnected. Check which end is disconnecting the call. Whether it is the calling side or the called side. This will help in narrowing down the issue.

[ake_astrom]

Hi and thanks for your replay. When I type "debug isdn q931" I have the reply from the router "Error in Input strin q931" the promt look like this namn>. Shuldent this be done in Exec mode When the promt look like this name#? How du I reach the Exec mode?

Best regards //Ake