Hi
I am setting up a C857 to try and accept remote access VPNs from The GreenBow IPSec client.
I have gone through the EasyVPN server setup, using 3DES and MD5 all the way through, and binding the VPN to dialer0
If I connect using TGB I get to sending Phase2 ID and then it stops, to get Phase1 to complete I have to switch to aggressive mode, and I don't see anywhere in CCP to specify things like mode or Phase2 IDs?
Am I missing something here?
My 857 is not set to be a DHCP server, can it still allocate IPs to the VPN clients?
Am I missing something more fundamental?
I do get a UNEQUAL_PAYLOAD_LENGTHS warning in the TGB console, followed by an R_U_THERE.
On a Zyxel USG - this takes about 10 seconds to setup - but I want to get it working on Cisco!
Any advice happily accepted!
Thanks!