There are a lot of options available to configure with Anyconnect, so I am not really sure what you are trying to achieve.
Here is a basic Anyconnect config to get you started:
ENABLE WEBVPN:
ASA(config)# webvpn
ASA(config-webvpn)# enable outside
ASA(config-webvpn)# anyconnect image disk0:/<anyconnect_pkg>
ASA(config-webvpn)# anyconnect enable
ASA(config-webvpn)# exit
LOCAL USER:
ASA(config)# username test password test123
ASA(config)# username test attributes
ASA(config-username)# service-type remote-access
ASA(config)# exit
CREATE IP POOL:
ASA(config)# ip local pool VPN-POOL 192.168.0.1-192.168.0.254 mask 255.255.255.0
GROUP-POLICY:
ASA(config)# group-policy TEST internal
ASA(config)# group-policy TEST attributes
ASA(config-group-policy)# vpn-tunnel-protocol ssl-client ssl-clientless
ASA(config-group-policy)# address-pools value VPN-POOL
ASA(config-group-policy)# exit
TUNNEL-GROUP:
ASA(config)# tunnel-group TEST type remote-access
ASA(config)# tunnel-group TEST general-attributes
ASA(config-tunnel-general)# default-group-policy TEST
ASA(config-tunnel-general)# exit
ASA(config)# tunnel-group TEST webvpn-attributes
ASA(config-tunnel-webvpn)# group-alias ANYCONNECT-TEST
ASA(config-tunnel-webvpn)# exit
At this point you should be able to connect using Anyconnect by entering the IP or hostname of the outside interface. If you do not already have Anyconnect installed you can connect with your browser (also using ASA outside IP) and download and install Anyconnect.
