hi everybody
I want to config ptmp on 2811 with 2 point in other cities. could you pls check my configuration & tell me about the errors. I should use channel-group or pri-group ? I don't know . do I set switch-type for ptmp or not?
pls help me.
!
card type e1 1
!
no network-clock-participate aim 0
no network-clock-participate aim 1
no aaa new-model
ip subnet-zero
!
!
ip cef
!
!
no ftp-server write-enable
!
!
controller E1 1/0
framing NO-CRC4
linecode hdb3
clock source line
pri-group timeslots 1-2
pri-group timeslots 3-4
!
!
interface FastEthernet0/0
ip address 192.168.104.254 255.255.255.0
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial1/0:1
ip address 192.168.1.82 255.255.255.252
encapsulation ppp
no keepalive
!
interface Serial1/0:2
ip address 172.16.104.1 255.255.255.252
encapsulation ppp
!
ip classless
ip route 192.168.2.0 255.255.255.0 192.168.1.83
ip route 172.16.105.0 255.255.255.0 172.16.104.2
no ip http server
!
!
!
control-plane
!
!
line con 0
line aux 0
line vty 0 4
login
line vty 5 15
login
!
scheduler allocate 20000 1000
!
end
#
