Configure PRI to support Bonding Mode 1

[alan_kallas]

I have an existing PRI interface working for 64K and multilink PPP calls.

I need to provide support on this interface for incomming 128K connections using ISDN Bonding Mode 1.

I cannot find the commands on the controller to activate this function - any advice?

Thanks in advance for your assistance.

Regards

Alan Kallas

[amritpatek]

Bonding calls (PRI Gateways only)

Internal Imux providing calls at 128 Kbps (2B) up to full PRI of 1472 Kbps (23B) for T1 and up to full PRI of 1920 Kbps (30B) for E1 using bonding mode 1.

Parallel dialing for bonded calls.

Internal Imux providing calls at 128 Kbps (2B) up to 512 Kbps (8B) using bonding mode 1.

The Cisco IPVC 3521 BRI Gateway enables direct video, voice, and data communication between an H.320 (ISDN) terminal and H.323 (IP) terminals at bandwidths of up to 512 Kbps (4 BRI lines) using bonding mode 1 ).

The Cisco IPVC 3526 PRI Gateway and Cisco IPVC 3540 PRI Gateway enable direct video, voice, and data communication between an H.320 (ISDN) terminal and H.323 (IP) terminals at bandwidths of up to 1472 Kbps (23B bonding for T1) and up to 1920 Kbps (30B bonding for E1) .