Dynamic map seq number change in ASA 5510

[mats.karneman]

Hi all

I am migrating from 3005 to ASA 5510. (no previous experience vit ASA/PIX before) Everything works ok exept one irritating issue.

I added in (ASDM)a remote access VPN for use with client and Easyvpn, works fine. When i after that add a site to site VPN the seq nbr on the dynamic map will change and all connected remote access VPN's will disconnect. I have tried to set the seq nbr on the dynamic map to 65535 (with telnet session) but when i add the next L2l (via ASDM wizard) it is changed back to "100" or whatever is the next in range. Anyone out there who knows if there is a way to prevent this ?

brgds

Mats

[a-vazquez]

What is the software version which your are using in the ASA?

[mats.karneman]

Hello

It is 7.2.1 and ASDM 5.2.1

thx

[support365]

Hi Mats,

We have the same versions and suffer the same issues. Did you ever find a solution, to the problem.

thanks

phil

[mats.karneman]

Hi

noop I didn't. I left the VPN clients on the 3005 concentrator and use the ASA for Lan to Lan only.

rgds

Mats

[support365]

Thanks for the prompt reply Mats,

Will just have to suffer knocking off my VPN remote access clients each time the ASDM Wizard wants to write config for a new lan-to-lan VPN.

rgds

phil.