yes you can have it...
lets say router A is hub router and having two spoke router B and router C...
now you can have DLCI like
router A use DLCI 101 to reach B
router A use DLCI 102 to reach C
Router B can use DLCI 201 to reach A and C
Router C can use DLCI 301 to reach A and B
by this way you can have partial mesh configuration and you can have configuration like this...
Router B can use DLCI 201 to reach A
DLCI 202 to reach C
Router C can use DLCI 301 to reach A
DLCI 302 to reach B
hope this will clear your idea
rate this post if it helps
regards
Devang