We have two 500 meg layer 2 links with ethernet presentation. Each end of these links connected to the outside interface of an ASA firewall in active standby. So four firewalls total.
When I configure an IPsec between them and failover one end, the tunnel fails over correctly. When I failover back to the primary, it stalls until manually cleare in the ASDM or cli.
I dont really understand why it works at all rather than just the first time so would appreciate some assistance. Is some sort of tracking required? I've attached a diagram which I hope helps.
Running asa912-smp-k8.bin and asdm-713.bin
