Hello,
I am trying to setup a VPN tunnel between 2 sites (ASA5510 and Juniper) but running into few issues.
My site is using ASA5510 while secondary site is using Juniper. The network Admin in the site with Juniper hardware setup the VPN tunnel and sent me info such as IPs, phase1 and 2 proposal...etc to setup my side.
Phase1 proposal: pre-g2-3des-sha
Phase2 proposal: g2-esp-3des-sha
On the ASA>Monitoring I see 0 for Bytes Tx and xxxxx for Bytes RX.
I have setup the Tunnel using the Wizard on ASA.
Not sure if the exact problem or how to troubleshoot. The network admin from other site (Juniper) tells me to check my route configuration but not sure if further configuration must be made on ASA. I had to make changes to IKE Proposal and change lifetime (seconds) to 28800 to match on the Juniper side.
Thanks...B