Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1047
Views
5
Helpful
1
Replies

Non identical Anyconnect configuration on ASA failover units

somerset-cc
Level 1
Level 1

‎01-20-2011 06:48 AM - edited ‎02-21-2020 05:06 PM

I've got an issue that I have 2 x 5540's in active/standby configuration. version 8.3.24.

The primary unit has Anyconnect profiles, xml files that are used with anyconnect users.

I also have scripts for the anyconnect sessions.

The anyconnect profile has not been passed across to the standby unit but the scripts are there.

Is this normal behaviour?

I means that if users connect to the failover device it will not work properly?

I am assuming there is not supposed to be anything that is not identical for these 2 boxes. They have all other configuration

identically that i can see.

Thanks

Sam

1 person had this problem
Labels:
0 Helpful
1 Reply 1

rahgovin
Level 4
Level 4

‎01-20-2011 07:57 AM

Unfortunatley, this is the expected behaviour. AnyConnect profiles are not replicated to the standby unit automatically and it has to be done manually. There is an enhancement request made for the same here with this id: CSCsr31403

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsr31403

Customers Also Viewed These Support Documents