03-03-2014 04:53 PM
hi , I am not able to remote vpn when I connect with my data card.
VPN login is success.
But when I trace to my LAN ip it takes the internet path.
attaching the routing table of my pc
thanks
vivk
03-04-2014 09:48 AM
What is the IP address space of the corporate network? What is the address space of the internal network? Are you using dhcp on the internal remote network? If so, is the internal gateway correctly configured within the dhcp scope? If so, why do you have a persistent default route?
Sent from Cisco Technical Support iPad App
03-04-2014 11:22 AM
With Cisco VPN client, especially whe configured to tunnel all traffic, the persistent route is added once VPN is built.
However the difference from what normally should be and the screenshot: the persistent route is missing from the main routing table.
Something is wrong with your laptop.
03-05-2014 06:19 AM
not with my laptop, its seen with all the people irresprctive who uses this data card model.
But with my same laptop, if I use a cable internet, it works fine.
03-05-2014 06:41 AM
Hello,
The WWAN cards are not supported.
You could try updating the DNE driver though and check if there is any difference.
http://www.citrix.com/go/lp/dne.html
Otherwise, you may use AnyConnect.
HTH.
- Javier
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide