Packet tarcer IP sec issue

[chamarag6]

Hi All,

I'm trying to config the IPSec VPN tunnel in packet tracer (PT) and it throws an error as below after config the VPN this error comes when I start the Ping test

I can not clear the IPsec VPN because the command doesn't work on PT

Scenario
I have 3 branches
All connecting to the same ISP

HQ
BR1
BR2
VPN is configured on all the routers

All the Branches connect to HQ  (HQ to BR / HQ to BR2) and Branches should be able to ping between branches  (BR1 to BR2)

Help will be much appreciated because it's an assignment from my uni that is due date is closing soon

[chamarag6]

Yep All good It's working ping for both BRs

I tried with other PC 's and it's works

Just randomly select PC's in HQ and BR1 and BR2 and it working

[Flavio Miranda]

Hi

 This file have Wireless, Firewall and all hosts pinging. I will enable the VPN on the next version.

[Flavio Miranda]

Hello

 This file we have all in place and it is pinging. However, I dont believe it is going to work with 3 VPN tunnel. I am suspicious that the PT have some limitation. 

Luckly, you dont need 3 riight. I believe you need only two.

 I will keep digging on it just for curiosity but I am quite convinced that it will not work with three peer. If I manage it to work, I will share here.

[chamarag6]

Hi

I also think that an issue with PT I think will be fine I'll have a look and let you know

[Flavio Miranda]

On this file, HQ ping branch1 through the VPN tunnel but ping Branc2 out of the VPN tunnel.

The same for Branch1 and Branch2.

Let me look in the firewalls.

[Flavio Miranda]

On this file, all the host can ping each other.

 Take a look on how I did to send traffic inside the tunnel or outside the tunnel.

Next release must be the final one.

[Flavio Miranda]

V8

[Flavio Miranda]

Connectivity among all sites OK

Firewall with 3 zones OK

VPN - in progress

[Flavio Miranda]

DHCP working

[Flavio Miranda · Accepted solution]

all good.