Remote VPN Client issue

[GarrethSpeer]

I'm a newbie with PIX firewalls.

I currently have a PIX 501 and I am trying to setup a VPN tunnel from a VPN client behide a Linksys router to the PIX 501 firewall. I am able to establish a connection to the PIX but I cannot connect anywhere behind th PIX once connected. Both networks have same internal IP range so would this cause a problem. Also I would liek to do split tunneling for internet access.

Please see my config attached

Thanks

[jackko]

both network have the same internal ip scheme will definitely an issue. further, the vpn client pool on the pix should not overlap with the pix inside net.

thirdly, please apply the commands below:

isakmp identity address

isakmp nat-traversal 20