We have multiple route based tunnels from a single ASA to Velocoud devices. All Velo tunnels are exhibiting strange behavior where the IPSec traffic selector gets reset to two /32s, the local and remote peer IP addresses. I have to go in and remove the peer IP from the Tunnel interface to get it to reset back to 0.0.0.0/0 for local and remote. The occurrence frequency is totally random and it appears to happen on a tunnel re-key.
Has anyone else seen this type of issue and if so, was there any resolution? I'm assuming it is an issue connecting to a Velo device since we have other route based tunnels to ASAs which are rock solid.
TIA!
