05-17-2005 02:21 PM
Hi
I have a site to site vpn setup and working fine. Lets say the private addresses on two ends are 1.1.1.1 and 2.2.2.2 Now, I need to reach an address 3.3.3.3 using a gateway at 1.1.1.45 through VPN from 2.2.2.2 Is ths possible? I added an access list statement to encrypt traffic destined to 3.3.3.3 so it gets sent through vpn but how routing will work? I added a route statement to the Pix but it appears that it is not being used. Any ideas are appreciated.
Thanks & Regards,
--Naresh
05-17-2005 06:51 PM
I think you need to add the 3.3.3.3 network to the inside of the pix that is on the 3.3.3.3 side.
05-30-2005 02:45 AM
Hi Narang,
Pls go thro this link
HTH,
Rajesh
05-30-2005 08:40 AM
Thanks Rejesh, this issue was resolved a while back. I just wanted to confirm that routing specified on pix does actually take effect for vpn traffic, which has been verified.
Regards,
--Naresh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide